|
SOCKET PLCC-523M
|
x 1 |
a600_rgb2hdmi plcc adapter
A useful solution for those wanting to use copperdragon based rgb2hdmi board on a A600
Found at https://github.com/dtheodor79/A600-RGB2HDMI
Towards intercepting the original Denise RGB signals, certain solutions use a PCB with a flexbile cable that connects them to the RGB adapter or a custom PCB with a cut-off in the middle.
This solution somehow "merges" the previous approaches; it is based on a small PCB that is used to intercept RGB signals from the A600 Denise chip and deliver them to the Raspbery Pi zero. On its bottom side, the PCB houses a PLCC-52, and on its top side a set of pins for mouting the Denise Amiga adapter PCB that is available on hoglet67 Github page. As suggested, the adapter CLK signal is fed from Denise's 7MHz signal.
This is the PCB stack that enables the HDMI output:
And this is a 3D image from KiCAD:
Finally, these are a few images that show how I successfully installed it on my A600:
Hope you find it useful!
a600_rgb2hdmi plcc adapter
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(1)
- (DIY) C64iSTANBUL Oct 22,2021
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Matthew Pegg
-
-
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
648 0 0 -
RF Control training board for students based on ESP32 C3
833 0 2 -
Aquarius+ Computer, Standard PCB
1101 0 7 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
704 0 2 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
604 0 1