SYMEF Drill Template-Rev0
Use this template to mount a SYMEF Type S amplifier horizontally on a large heatsink with transistors mounted horizontally. Eg, using a Dissapante 5U chassis will allows the amplifier boards to be mounted on the heatsink.
Drill using 2.5mm drill, then tap to 3mm. It is recommended to drill and tap mounting holes one at a time, and then secure the template in place with screws before drilling holes for transistors.
After each mounting hole has been drilled and tapped, the corresponding hole in the template can be drilled out to 3mm thus allowing it to be secured with an M3 screw.
N.B. One Template is required for each amplifier PCB, i.e. two drilling template boards are needed for a stereo amplifier.
Template provided courtesy of Audio Nautica.
SYMEF Drill Template-Rev0
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Stephen Audio Nautica
-
-
-
-
-
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
670 0 0 -
RF Control training board for students based on ESP32 C3
853 0 2